Maintenance of drilling machine by drilling machine manufacturer

Release time:

2020-09-19


Drilling rig is a kind of common drilling equipment. Due to the problems of working environment and time, this equipment will lose a lot, so it needs frequent maintenance. The advantage of this is that it can reduce the frequency of equipment failure and extend the service life of the equipment.

钻井机


Since it is maintenance, it is necessary to select those parts with high loss rate. The primary protection object is the filter element, which plays the role of filtering impurities in the oil or gas circuit to prevent it from invading the system to form problems; various filter elements should be replaced regularly according to the requirements of (operation protection manual); when replacing the filter element, check whether the old filter element There is metal adhesion. If metal particles are found, they should be diagnosed and improved in time; use pure filter elements that meet the rules of the machine.

钻井机


Then there is the fuel. According to the different ambient temperature, choose diesel with different trademarks; diesel cannot be mixed with impurities, ash and water, otherwise the fuel pump will wear out prematurely; low-quality fuel has high white wax and sulfur content, which will cause harm to the engine; after daily operation, The fuel tank should be filled with fuel to prevent water droplets from falling on the inner wall of the fuel tank; before daily operation, open the drain valve at the bottom of the fuel tank to drain.

钻井机


Finally, grease protection. The choice of lubricating oil (butter) can reduce the wear of the moving surface and avoid noise. Grease in storage and preservation, should not be mixed with dust, sand, water and other impurities; recommend the use of lithium-based grease G2-L1, good wear resistance, suitable for heavy load conditions; filling as far as possible the old oil all out, wipe clean, to avoid sticky sand.